360 Part (Virtual web hosting) III . Choosing and Installing a
360 Part III . Choosing and Installing a Linux Distribution Be extremely careful using the Remove All Partitions option, and if at all possible, avoid using it at all because you can accidentally destroy your Mac OS installation! Keep all partitions and use existing free space. The one you want to use in most cases, because it won t alter your Mac OS or Mac OS X installations and uses only the identified free space (as created previously). This is the option you should select if you are using Automatically partition. Manually Partition with Disk Druid This is the more advanced option that allows you to create your partitions to your preference. Here is the sequence for creating new Linux partitions: Choose the drive on which you want to install Yellow Dog Linux. Choose New to create a new partition. You must create three partitions. First, choose Filesystem Type.Apple BootStrap. No mount point is needed. It should be 1MB and fixed size. This partition is for booting and should be the very first partition. Second, choose Filesystem Type.Swap. No mount point required. It should be a minimum 256MB (256MB is generally enough, although some say this should be set to twice the size of your physical RAM. More won t degrade system performance, though, and it doesn t hurt to be safe) and fixed size. This partition is the swap space that Linux uses for processes when the RAM is full. Third, create your root partition by selecting / as the mount point. This is where the file system is mounted. The root partition is absolutely critical because your other file systems will mount from this. You generally want to have your root partition consume the rest of the hard drive unless you are creating more partitions. Additional partitions are optional. 9. Identify your network settings, including DHCP. You use your network configuration for LAN (local area network) connections, such as when you are using a router between your cable or DSL connection and the local, internal network. You should know these settings ahead of time, so be sure to check them out before you start. Refer to Chapter 5 for descriptions of IP addresses, netmasks, and other information you need to set up your LAN. Select eth0 (your first network interface card) and click Edit. You have the following options: Configure using DHCP Enables you to automatically obtain a DHCP address from your LAN if there is a DHCP server (such as Linksys or D-Link Routers). If you check here, you do not need to fill out anything else in this section. Activate on boot Enables you to turn on your network connection during boot. Under most circumstances you will want to do so if you are using a LAN. Cross- Reference Caution
We recommend high quality webhost to host and run your jsp application: christian web host services.